Digital Clock Instructions

Digital clock basic instructions may vary depending on the product as the product are made from different factories.
The instructions below are a generic/basic version and works on most spyware digital clocks.
Once you have recorded data, copy the contents of the memory card to your computer, as a backup, and to minimize delays.
Please charge the Spyware digital clock for a minimum of 4 hours using the supplied cable.
Please note. The recording mode does not work when the cable is plugged to the computer. When the cable is used, the Digital clock goes into charging mode and the memory card is accessible via the computer.

Preparing the Digital clock for recording.
Ensure you have formatted the Micro SD Card. Maximum 32 Gigabyte.
Ensure you have places a Micro SD Card inside.
Turn the switch to on position.

Taking Pictures:

Place the switch to “on” position.
The blue light will switch on, this indicates it is in standby mode.
Press the “Camera” button, it will take a picture, the blue light will flash once, then it will return back to blue light (standby mode)
Press the power button to switch the clock off
Place the switch to “off” position.
Connect cable to your PC and Digital clock.
Go to the folder called “Image”, Recommended, copy the contents of the memory card to your PC, as a backup, and to minimize delays when viewing.
Double Click the file you wish to view.

Recording Sound:

Place the switch to “on” position.
The blue light will switch on, this indicates it is in standby mode.Press the Sound button, The digital clock blue light will flash 1/2 times, then switch off, It is now recording sound.
To stop the recording press the sound button, The blue light will switch back on (standby by mode).
Connect cable to your PC and Digital clock.
Go to the folder called “Audio”, Recommended, copy the contents of the memory card to your PC, as a backup, and to minimize delays when viewing.
Double Click the file you wish to listen to.

Recording Video:

Place the switch to “on” position.
The blue light will switch on, this indicates it is in standby mode.

Press the Video button, The digital clock blue light will flash 3/4 times, then switch off, It is now recording video.
To stop the recording press the video button, The blue light will switch back on (standby by mode).
The max length for the video recording is 20 minutes.
Connect cable to your PC and Digital clock.
Go to the folder called “video”, Recommended, copy the contents of the memory card to your PC, as a backup, and to minimize delays when viewing.
Double Click the file you wish to view.
Motion Detection:

Place the switch to “on” position.
The blue light will switch on, this indicates it is in standby mode.

Press the Motion Detection button, The digital clock blue light will flash 1 – 2 times, then switch off, It is now motion detection mode.
To stop the recording press the motion detection button, The blue light will switch back on (standby by mode).
The maximum recording time for the file is 3 minutes.
Connect cable to your PC and Digital clock.
Go to the folder called “Video”, Recommended, copy the contents of the memory card to your PC, as a backup, and to minimize delays when viewing.
Double Click the file you wish to view.

 

Troubleshooting

  • No Blue light – Ensure the Spyware digital clock switch it turned to “on” Position.
  • No Blue light – Ensure the battery is charged.
  • Blue light is flashing rapidly – The battery is low, Recharge the battery.
  • Remote control is difficult to use – Ensure you have line of site from remote control to the device. Ensure you battery has power. Ensure you have remove the plastic insulator between battery and remote control.
  • Cannot connect with the computer – Replace the Data cable
  • Sound is recorded with noise or video is not clear – Recharge the battery, Replace the memory card.